SRY3 Tubular Electric Heater 220V 6KW Precautions:
1. The overall dimensions "B" must be fully immersed in oil to avoid burning the components. The heated oil should be non-corrosive.
2. When melting solid oils such as asphalt and paraffin, the voltage should be reduced during use, and then raised to the rated voltage after melting. This prevents heat concentration and reduces the service life of the components.
3. If carbon deposits are found on the surface of the tube, they must be completely removed before reuse to avoid reducing efficiency or even burning out the components.
4. The components should be stored in a dry place. If the insulation resistance drops below 1 megohm due to long-term storage, it can be dried in an oven at about 200°C for several hours (or powered at low voltage for several hours) to restore the insulation resistance.
SRY3 Tubular Electric Heater 220V 6KW Functional Features:
Small size, high power: The heater mainly uses clustered tubular electric heating elements
2. Fast thermal response, high temperature control accuracy, and high overall thermal efficiency.
3. High heating temperature: The heater is designed with a maximum working temperature of up to 850°C.
4. Uniform medium outlet temperature and high temperature control accuracy.
5. Wide application range and strong adaptability: The heater can be used in explosion-proof or ordinary occasions, with explosion-proof levels up to dIIB and C, and pressure resistance up to 20MPa.
6. Long service life and high reliability: Made of special electric heating materials, designed with low surface power load, and equipped with multiple protections, greatly enhancing the safety and lifespan of the electric heater.
7. Fully automatic control: According to requirements, through the heater circuit design, automatic control of outlet temperature, flow rate, pressure and other parameters can be easily achieved, and it can be networked with computers.
8. Significant energy-saving effect: Almost 100% of the electric energy is converted into heat and transferred to the heating medium.
Manufacturer Introduction:
1. This model of electric heater is manufactured by imitating German products. The electric heater consists of a heating core and a protective sleeve. The heating core uses tubular electric heating elements as the heat source, and the protective sleeve is made of thin stainless steel tubes. The wiring device is protected with a bolted shell seal, which is waterproof, moisture-proof, and oil-proof.
2. The protective sleeve and the oil tank body are connected with straight thread, providing strong sealing. The protective sleeve isolates the core from the heated oil. When replacing the electric heater, there is no need to drain the oil from the tank; simply extract the heating core, making maintenance convenient.
3. The surface power of this model of electric heater is designed according to the JBT2379-93 standard, and the surface power should be selected at ≤0.7W/cm².
Product Uses:
Used for heating hydraulic and lubricating oil in hydraulic and lubrication devices, and also for heating non-corrosive gases or liquids.
